TROUBLESHOOTING PRECAUTIONS WHEN CARRYING OUT MAINTENANCE (4) When the wiring harness clamp of the connector has been removed, always return it to its original condition and check that there is no looseness of the clamp. c) DRYING WIRING HARNESS If there is any oil or dirt on the wiring harness, wipe it off with a dry cloth. Avoid washing it in water or using steam. If the connector must be washed in water, do not use high pressure water or steam directly on the wiring harness. If water gets directly on the connector, do as follows: (1) Disconnect the connector and wipe off the water with a dry cloth.
i If the connector is blown dry with air, there is the risk that oil in the air may cause a faulty contact, so avoid blowing with air. (2) Dry the inside of the connector with a dryer. If water gets inside the connector, use a dryer to dry the connector. i Hot air from the dryer can be used, but be careful not to make the connector or related parts too hot, as this will cause deformation or damage to the connector. i (3) Carry out a continuity test on the connector. After drying, leave the wiring harness disconnected and carry out a continuity test to check for any short circuits between pins caused by water.
Ъ After completely drying the connector, spray it with contact restorer and reassemble. 20-109 WA250-3L