TROUBLESHOOTING PRECAUTIONS WHEN CARRYING OUT MAINTENANCE (4) Action to take after removing connectors. After removing any connector, cover it with a vinyl bag to prevent any dust, dirt, oil, or water from getting in the connector portion. b) CONNECTING CONNECTORS (1) Check the connector visually. ! Check that there is no oil, dirt, or water stuck to the connector pins (mating portion). ! Check that there is no deformation, faulty contact, corrosion, or damage to the connector pins. ! Check that there is no damage or breakage to the outside of the connector. i If there is any oil, water, or dirt stuck to the connector, wipe it off with a dry cloth.
If any water has gotten inside the connector, warm the inside of the wiring with a dryer, but be careful not to make it too hot as this will cause short circuits. i If there is any damage or breakage, replace the connector. (2) Assemble the connector securely. Align the position of the connector correctly, then insert it securely. For connectors with a lock stopper: Push in the connector until the stopper clicks into position. (3) Correct any protrusion of the boot and any misalignment of the wiring harness. For connectors fitted with boots, correct any protrusion or the boot.
In addition, if the wiring harness is misaligned, or the clamp is out of position, adjust it to its correct position. i When blowing with dry air, there is danger that the oil in the air may cause improper contact, so clean with properly filtered air. 20-108 WA250-3L