Komatsu — CHECKS BEFORE TROUBLESHOOTING

TROUBLESHOOTING CHECKS BEFORE TROUBLESHOOTING CHECKS BEFORE TROUBLESHOOTING 20-113 WA250-3L Item Judgement standard Remedy Checks before starting Lubricant, coolant 1. Check fuel level, type of fuel — Add fuel 2. Check for dirt or water in fuel — Clean, drain 3. Check hydraulic oil level — Add oil 4. Check filter (hydraulic, transmission, torque converter) — Replace 5. Check oil level — Add oil 6. Check engine oil — Add oil 7. Check coolant level — Add coolant 8. Check clogging of dust indicator — Clean or check Electrical components 9. Check for loose or corroded battery terminals or wiring — Tighten or replace 10.

Check for loose or corroded alternator terminals or wiring — Tighten or replace 11. Check for loose or corroded starting motor terminals or wiring — Repair or replace 12. Check operation of gauges — Repair or replace Other check items Hydraulic, mechanical components 13. Check for abnormal noise or smell — Repair 14. Check for oil leakage — Repair 15. Bleed air from system — Bleed air 16. Check effect of brakes — Adjust or repair Electrical components 17. Check battery voltage (engine stopped) 23 - 26V Repair or replace 18. Check battery electrolyte level — Add electrolyte or replace 19. Check for discolored, burned, or bare wiring — Replace 20.

Check for missing wiring clamps, hanging wires — Repair 21. Check for water on wiring (check carefully for water at connectors and terminals) — Dry place affected by water 22. Check for broken or corroded fuses — Replace 23. Check alternator voltage (engine running at over half throttle) (If the battery charge is low, it may reach approx. 25 V immediately after starting) — 27.5 - 29.5V Replace Repair or check 24. Noise when battery relay is operated (turn starting switch ON-OFF) — Replace