TROUBLESHOOTING PREVENTING RECURRENCE OF TROUBLE PREVENTING RECURRENCE OF TROUBLE ! The troubleshooting table is used to establish the direct cause of damage or breakdown of a part or piece of equipment. It is not able to establish the root cause of the damage or failure, however. ! Also, this table only describes the action to be taken with the particular part or piece of equipment. It does not mention what action should be taken to prevent a recurrence of the root cause. ! In order to remove the root cause of a fault so as to prevent a recurrence, carefully investigate the real cause while referring to the following items. !
Regarding the method of checking and adjusting each part or piece of equipment, refer to "Testing and Adjusting" in the Shop Manual. Water: Oil storage tank, breather, etc. HYDRAULIC EQUIPMENT Sand: Oil replenishing or replacing 1. Oil checks method, etc. ! The fundamental cause of almost all faults Rubber: Cylinder packing, etc. occurring in hydraulic equipment is the Metal: Wear or damage to hydraulic inclusion of water, air or other foreign matter in equipment such as pump and the oil. Accordingly, it is necessary to check motor, as well as transmission the oil to see whether or not it contains any of and torque converter, etc. the above substances, and then take appropriate action.
3) Oil cleaning and replacement ! If a large amount of metal particles or other 1) Oil checks foreign matter is discovered in the oil, ! Check for water contamination. either wash the oil using an oil refresher or Check the oil for possible water replace it. contamination by means of a diesel Ъ If the oil is contaminated by water, it is engine oil checker or a hot plate. not possible to remove the water by ! Check for contamination of other means of an oil refresher. foreign matter. Remove the drain plug Ъ When washing the oil, also wash or and filter, then check the bottom of the replace the strainer and replace the tank and also the filter to see if any filter.
foreign matter has collected there. Check the degree of contamination by 2. Cleaning fragments of damaged parts means of a contamination checker. ! If a part becomes damaged, fragments may ! Viscosity check pass into the oil line. It is thus necessary to Check the viscosity of the oil using a wash the oil. viscometer in order to confirm whether ! In addition, disassemble and wash such parts or not the oil is satisfactory.
as valves and cylinders which are liable to 2) Check of contamination point collect metal fragments and other foreign If, as a result of the above checks, it is matter, thus helping to prevent a recurrence of discovered that the oil is contaminated by faults due to such fragments becoming lodged water or other foreign matter, it is in various parts of the engine or hydraulic necessary to find out where the equipment. contamination is occurring and also to take steps to prevent it. 20-117 WA250-3L