Komatsu — PRECAUTIONS WHEN TROUBLESHOOTING

TROUBLESHOOTING PRECAUTIONS WHEN TROUBLESHOOTING To decide which of the two is the location of ! When removing parts, check their condition of the failure, refer to “JUDGMENT ON POWER mounting, and distinguish between front and rear, TRAIN”. left and right, and top and bottom. 5) Carry out troubleshooting using the ! Check the match marks, or make match marks to troubleshooting charts. prevent mistakes when installing. There are the following two types of troubleshooting charts. ! If part cannot be removed even when the nuts and bolts have been removed, do not use excessive 1. TROUBLESHOOTING TABLE force to remove it.

Check the part to see if there is POWER TRAIN any problem with it and remove the problem before STEERING SYSTEM trying to disassemble the part. BRAKE AND AIR SYSTEM WORK EQUIPMENT SYSTEM ! When installing or assembling, clean off all dust 2. TROUBLESHOOTING FLOW CHART all grease or oil before coating with gasket sealant. ELECTRICAL SYSTEM and dirt and repair any scratches or dents. Remove The troubleshooting charts consist of: 1) Items which can be checked easily. 2) Items which are likely to be the cause of such failures. Follow theses charts to carry out troubleshooting. At the same time, do not forget the following points. ! Check related items. !

Check that there are no other failures or breakdowns. 6) Investigate causes of breakdown ! Even if the breakdown is repaired, if the original cause of the problem is not removed, the same breakdown will occur again. To investigate and remove the original cause, see "Actions to take to prevent failures from occurring again". 3. PRECAUTIONS WHEN REMOVING, INSTALLING, DISASSEMBLING OR ASSEMBLING PARTS DURING TROUBLESHOOTING ! Carry out the various testing and adjusting while observing the items on quality control given in "Testing and Adjusting". 20-116 WA250-3L