Komatsu — PRECAUTIONS WHEN TROUBLESHOOTING

TROUBLESHOOTING PRECAUTIONS WHEN TROUBLESHOOTING PRECAUTIONS WHEN TROUBLESHOOTING 1. SAFETY b. Was there anything unusual before the ! Stop the machine on level ground, and check machine broke down? that the safety pins and parking brake are c. Did the breakdown occur suddenly, or had correctly applied, and that the tires are there been signs of trouble before? blocked. d. What was the machine doing when break down occurred? ! When working in groups, use agreed upon e. Had the machine been repaired before the signals and do not allow unauthorized breakdown? If so, who carried out the repair, persons near machine. and when? !

Be careful not to get burned by hot parts or get caught in rotating parts. 2) Check the following items which can be f. Had the same kind of failure occurred before? checked simply by visual checks etc. ! Always disconnect the cable from the a. Check oil level. negative (-) terminals of the battery before b. Check for leakage of oil from piping or disconnecting any wiring. hydraulic equipment. ! Always release the pressure before removing d. Check stroke of spool in control valves. the plugs or caps of any place under hydraulic or air pressure, and connect all 3) Reenact the failure and check the condition of measuring tools correctly. the machine (particular conditions at the time c.

Check travel of control levers. of failure). 2. METHODS FOR TROUBLESHOOTING a. Ask the user or operator if the decision about Ъ Just because a failure occurs, do not the failure was made based on measured immediately start to disassemble the machine. values, or by comparison, or by feeling. b. Compare extent of failure with standard values. ! The machine may be disassembled in such a ! Check safety before carrying out any way that the problem cannot be located, so the check. cause of the problem will be unknown. ! Did not make any check or measurement As a result, that will make the condition worse. 4) Try to locate the possible causes for the !

The customer and operator will lose confidence failure. in you. The transmission system consists of the ! Time will be wasted, and unnecessary costs will and the transmission electrical control. be incurred for excess parts and greasing. transmission itself, the transmission control valve, To avoid these problems, use the following procedure transmission system, the probable location of the when troubleshooting. failure can be divided as follows; In particular, when trouble occurs in the ! Transmission itself, or transmission control 1) Ask the customer and operator the following valve. questions about the breakdown. ! Transmission electric control. a.

Have there been any other problems apart from the one reported? 20-115 WA250-3L