TROUBLESHOOTING T-24, T-25 T-24 Bucket shakes during loading operation (Main control valve at HOLD) Checks before troubleshooting ! Is there play in the work equipment linkage pin, bushing? (Is there any abnormal noise?) Cause ! Defective bucket cylinder piston seal ! Defective operation of safety valve (with suction valve) at bucket cylinder rod end. If any other problem occurs at the same time, carry out troubleshooting according to the nature of the problem. T-25 Bucket dumps momentarily when control lever is operated from HOLD to TILT Checking problem !
When the engine is run at low idling and the bucket control lever is operated slowly from HOLD to TILT, the bucket dumps momentarily under its own weight. When the lever is operated fully to the TILT position, the condition returns to normal. Cause ! Defective seating of check valve for bucket spool in main control valve 20-183 WA250-3L