Komatsu — TROUBLESHOOTING DATA DISPLAY

TROUBLESHOOTING TROUBLE DATA DISPLAY TROUBLE DATA DISPLAY 1. Outline The speedometer display on the main monitor is used to display the troubleshooting for each control system. The nature of the troubleshooting is displayed as the failure action code, failure code, and the time elapsed since failure. The signals between the main monitor and each controller are transmitted in serial through the network circuit. (Only the engine controller uses a special parallel signal.) 2. Abnormality in failure action code This code informs the operator directly of the abnormality, and takes action, such as stopping the machine immediately. There are four types of action code:

E00, E01+CALL (E01 and CALL are displayed alternately), E03+CALL, and CALL. If a falure occurs suddenly, one of these codes is shown on the speedometer display. For details of the action taken by operator for the action codes, see Item 4. 3. Falure code and time elapsed since failure The failures detected by each controller are changed to a code and displayed. It is possible to tell from this code which system in which controller has failed, so carry out troubleshooting for the applicable controller. For failures that have occurred and been reset, the faiure code and the time elapsed since failure are displayed to make it easy to check failures that are not occurring at present.

The failure codes for failures that are now occurring flash, and the codes for failures that are not occurring light up. For details of the method of operating and transferring data to the trouble data display mode, see STRUCTURE AND FUNCTION for the main monitor. Note: If the engine is not stopped, it is impossible to switch to the trouble data display mode, so the codes for failures which can only be detected when the engine is operating light up. For the correspondence between the failure codes for each controller and the failed system, see Item 5. 20-221 WA250-3L