Komatsu — 2. PRECAUTIONS WHEN CARRYING OUT INSTALLATION WORK

DISASSEMBLY AND ASSEMBLY PRECAUTIONS WHEN CARRYING OUT OPERATION 3. If the part is not under hydraulic pressure, the following corks can be used. 2. Precautions when carrying out installation work ! Tighten all bolts and nuts (sleeve nuts) to the specified (KES) torque. ! Install the hoses without twisting or interference. ! Replace all gaskets, O-rings, cotter pins, and lock plates with new parts. ! Bend the cotter pin or lock plate securely. ! When coating with adhesive, clean the part and remove all oil and grease, then coat the threaded portion with 2-3 drops of adhesive. !

When coating with gasket sealant, clean the surface and remove all oil and grease, check that there is no dirt or damage, then coat uniformly with gasket sealant. ! Clean all parts, and correct any damage, dents, burrs, or rust. ! Coat rotating parts and sliding parts with engine oil. ! When press fitting parts, coat the surface with anti-friction compound (LM-P). ! After fitting snap rings, check that the snap ring is fitted securely in the ring groove. ! When connecting wiring connectors, clean the connector to remove all oil, dirt, or water, then connect securely. !

When using eye bolts, check that there is no deformation or deterioration, screw them fully, and align the direction of the hook. ! When tightening split flanges, tighten uniformly in turn to prevent excessive tightening on one side. i When operating the hydraulic cylinders for the first time after reassembling cylinders, pumps and other hydraulic equipment removed for repair, always bleed the air as follows: 1. Start the engine and run at low idle. 2. Operate the work equipment control lever to operate the hydraulic cylinder 4 - 5 times, stopping 100 mm from end of its stroke. 3.

Next, operate all hydraulic cylinders 3 - 4 times to the end of their stroke, then stop the engine and loosen air bleed plug (1) to bleed the air from the hydraulic tank. After bleeding the air , tighten plug (1). 4. Following this raise the engine speed , repeat the procedure in Step 3) to bleed the air. Repeat this operation until no more air comes out from the plug hole. Plug: 11.3 ± 1.5 Nm (1.15 ± 0.15 kgm) 5. After doing this, run the engine at normal speed. i When using the machine for the first time after repair or long storage, follow the same procedure.

30-7 WA250-3L Nominal number Part Number Dimensions D d L 06 07049-00608 6 5 8 08 07049-00811 8 6.5 11 10 07049-01012 10 8.5 12 12 07049-01215 12 10 15 14 07049-01418 14 11.5 18 16 07049-01620 16 13.5 20 18 07049-01822 18 15 22 20 07049-02025 20 17 25 22 07049-02228 22 18.5 28 24 07049-02430 24 20 30 27 07049-02734 27 22.5 34