DISASSEMBLY AND ASSEMBLY RADIATOR INSTALLATION Ъ Install radiator in reverse order of removal. Ъ Install so that the clearance between fan and fan guard is uniform Ъ Temporarily tighten the mounting bolts and fix the position, then tighten fully. Ъ When installing the radiator, the difference in the clearance between the fan and radiator on the left and right must be within 3 mm (0.12 IN). Ъ Install so that the clearance between the radiator fins and the front face of the fan is uniform at the top, bottom, left, and right. Ъ The difference between the left and right in the position of the radiator in the front-to-rear direction must be within 5 mm ((0.197").
Ъ Adjust so that the clearance between the shroud and fan is uniform. Ъ Be careful not to damage the fins on the radiator assembly. Ъ Tighten hoses without twisting. Radiator mounting bolts: 82 ±8 lbf.ft (112.8 ±9.8 Nm) (11.5 ±1.0 kgm) Radiator support mounting bolts: 82 ±8 lbf.ft (112.8 ±9.8 Nm) (11.5 ±1.0 kgm) Torque converter cooler hoses: 130 ±22 lbf.ft (176.4 ±29.4 Nm) (18.0 ±3.0 kgm) ! Refilling with oil and water 1) Tighten drain valve and add water through water filler to specified level. 2) Add transmission oil through oil filler to the specified level. Ъ Run the engine to circulate the oil through the system. Then check the oil level again. 30-22 WA250-3L