DISASSEMBLY AND ASSEMBLY ENGINE ENGINE Warning! Stop the machine on level ground and install the safety bar on the frame. Lower the bucket to the ground and stop the engine. Then apply the parking brake and put blocks under the wheels to prevent the machine from moving. Warning! Loosen the oil filler cap slowly to release the pressure inside the hydraulic tank. Then operate the control levers several times to release the remaining pressure in the hydraulic piping. Warning! Disconnect the cable from the negative (-) terminal of the battery. REMOVAL 1. Remove engine hood and radiator. Refer to “ REMOVAL OF RADIATOR” i For machines equipped with air conditioning:
Disconnect the heater hose, then remove the compressor together with the bracket, and move to the side. 2. Disconnect fuel control cable (1) at engine end. 3. Disconnect the following electric wiring: 1) Disconnect rear wiring connectors (2) from rear frame connectors. 2) Disconnect cable (3) between battery relay and starting motor from starting motor. 3) Disconnect wiring harness (4) for air intake heater at relay side. 4) Remove slow blow fuse box (5) and open cover, then disconnect wiring connector (6) between engine wiring and slow blow fuse. 5) Disconnect ground wiring (7) from staring motor. 6) Disconnect ground wiring (8) from alternator. 30-23 WA250-3L