Komatsu — ASSEMBLY

DISASSEMBLY AND ASSEMBLY TRANSMISSION 5) Insert gear (40) in shaft spline portion and secure with snap ring (39). 6) Coat mounting bolts with thread tightener, and install shroud (38). Ъ Wash and remove all oil and grease from the mounting bolt hole and mounting bolt. Ъ Insert the shroud from immediately above the gear, then turn over and assemble. Ъ Check that the gear does not interfere with the shroud. Mounting bolt: Thread tightener (LT-2) Mounting bolt: 110.3 ± 12.3 Nm (11.25 ± 1.25 kgm) Ъ After installing the shroud, remove the support plate. 2. Emergency steering pump gear (opt.) 1) Assemble O-ring (36-1) in groove of emergency steering pump gear (36).

2) There are places where there is interference inside, so insert bottom of gear first, then check inside and install emergency steering pump gear (36) slowly. Mounting bolt: 110.3 ± 12.3 Nm (11.25 ± 1.25 kgm) 30-55 WA250-3L