Komatsu — ASSEMBLY

DISASSEMBLY AND ASSEMBLY TRANSMISSION 3. Adjusting rotating torque of bearing 1) Turn over front housing (44). Ъ When turning over, be careful that the output shaft does not lean at an angle. Ъ Set a stand under the bottom surface of the top of the front housing. Ъ After turning over, hold the output shaft bearing cone in the bottom bearing cup. Ъ Install guide pin (44-1) (10 mm, P = 1.25, R = 100 mm). 2) Assemble desired shim (45) to parking brake retainer assembly (33), then tighten 3 mounting bolts (45-1) to specified torque. Do not install hub spline and O-ring spacer. Mounting bolt: 110.3 ± 12.3 Nm (11.25 ± 1.25 kgm) Ъ To settle the bearing, rotate the shaft while tightening.

After tightening, tap the end face of the shaft several times with a plastic hammer to settle the bearing again. Ъ Coat the bearing well with oil. Ъ Standard shim thickness: 0.95 ± 0.6 mm Bearing: Transmission oil Mounting bolt: 110.3 ± 12.3 Nm (11.25 ± 1.25 kgm) 3) Tighten coupling mounting bolts to shaft (37) and measure rotating torque. Ъ Rotating torque : 0.1 - 1 Nm (0.01 - 0.1 kgm) Ъ If a small torque wrench is not available, it is possible to measure as follows. Ъ Install plate (37-1) for measuring and retainer plate to shaft (37), and tighten coupling mounting bolts, then install pushpull scale to tip of plate (37-1) and measure. ! Plate length R : 100 mm !

Reading of push-pull scale : 1.0 - 9.8 Nm (0.1 - 1.0 kgm) Ъ When measuring the rotating torque, do not measure at the point where movement begins. Measure while it is rotating. Ъ If the rotating torque is not within the standard value, change the shim thickness to adjust again. 30-56 WA250-3L