Komatsu — ASSEMBLY OF FORWARD, REVERSE CLUTCH PACK

DISASSEMBLY AND ASSEMBLY TRANSMISSION 17. Spacer Assemble thrust washer (3), then assemble spacer (2). Ъ Check that the end face of the thrust race of the thrust washer is below the surface of the stepped portion of the shaft. 18. Bearing Press fit bearing (1). Ъ Press fit completely so that the spacer is in tight contact with bearing (1) at the stepped portion of the shaft. Ъ After press fitting the bearing, check that the clearance "b' between the thrust bearing and spacer is within the specified range. b = 0.07 - 1.33 mm 19. Clutch pack operation test Blow in compressed air through oil hole in shaft and check that each clutch works properly.

Ъ If the gear where the air is blown in is held in position, the clutch is working properly. 30-76 WA250-3L