DISASSEMBLY AND ASSEMBLY TRANSMISSION 4. End plate 1) Install tools B3 and B5, then tighten tool B4 to push in end plate (66). 2) Assemble ring (67) and remove tool B3. Ъ Check that ring (67) is fitted securely in the groove. Ъ Check that the disc rotates smoothly by hand. 3) Assemble thrust washer (38). 5. 3rd gear Assemble 3rd gear, then assemble needle bearing (36). Ъ If the gear spline does not match, turn lightly when assembling. Never use force to push it in. Ъ Assemble the needle bearing at the bottom first. 6. Bearing Assemble thrust washer (35) and spacer (34), and press fit bearing (33).
Ъ Check that the end face of the thrust washer is below the surface of the stepped portion of the shaft. Ъ Press fit completely so that the spacer is in tight contact with bearing (33) at the stepped portion of the shaft. Ъ After press fitting the bearing, check that clearance "d" between the thrust washer and spacer is within the specified range. d = 0.1 - 0.9 mm 30-78 WA250-3L