DISASSEMBLY AND ASSEMBLY TRANSMISSION 7. 1st piston 1) Turn over clutch pack. WARNING! When turning over the clutch pack, be careful not to get your fingers caught between the stand and clutch pack. 2) In the same way as with 3rd piston, make sure that piston seal fits well before assembling it to piston (32). 3) Assemble piston (32) in the same way as 3rd piston. Sliding surface of piston seal: Transmission oil 8. Clutch plate Assemble plate (28), disc (29), and spring (30) in turn to housing. Ъ Assemble in the same way as for the 3rd clutch plate. 9. End plate 1) Install tools B3 and B5, then tighten tool B4 to push in end plate (27). 2) Assemble ring (26) and remove tools B3 and B4.
Ъ Assemble in the same way as for the 3rd end plate. 3) Assemble thrust washer (23). 10. 1st gear 1) Assemble 1st gear (24) and needle bearing (25). Ъ Assemble in the same way as for the 3rd gear. 30-79 WA250-3L