DISASSEMBLY AND ASSEMBLY TRANSMISSION 2) Assemble needle bearing (25-1) and thrust washer (23-1). 11. Idler gear 1) Assemble idler gear (20) and install snap ring (22-1). Ъ Fit the snap ring securely in the shaft groove. 12. Bearing Assemble spacer (22) and assemble bearing (21) Ъ After press fitting the bearing, check that clearance 'c" between the washer and gear is within the specified range. c = 1.0 - 1.59 mm 13. Clutch pack operation test Blow in compressed air through oil hole in shaft and check that each clutch works properly. Ъ If the gear where the air is blown in is held in position, the clutch is working properly. 30-80 WA250-3L