Komatsu — ASSEMBLY OF 2ND AND 4TH CLUTCH PACK

DISASSEMBLY AND ASSEMBLY TRANSMISSION Assembly of 2nd and 4th clutch pack WARNING! The clutch pack is oily, so be careful not to let it slip when setting the clutch pack on the stand. Be careful also not to get your fingers caught between the stand and the clutch pack. Ъ Set the shaft housing on tool B1 with the 2nd clutch side at the top. 1. Piston seal Assemble piston seal (68-1) to piston (68). Ъ When assembling a new piston seal, use tool B7 to make the seal fit well (time: approx. 2 - 3 minutes), then assemble the seal. Ъ If the seal is assembled to the cylinder without making it fit first, the seal will be damaged. Inside surface of tool B7: Transmission oil 2.

2nd piston Install 2nd piston (68). Ъ Be careful not to damage the piston seal. Ъ Check that the spring pin does not extend from the circumference of the shaft. 3. Clutch plate Assemble plate (69), disc (70), and spring (71) in turn to housing. Ъ Soak disc (70) in clean transmission oil for at least 2 minutes before assembling. Ъ Be careful to assemble so that disc (69) and spring (71) are not resting on each other. Ъ Be careful that the plate or spring are not caught in the clutch housing ring groove when assembling. 30-81 WA250-3L