Komatsu — ASSEMBLY OF 2ND AND 4TH CLUTCH PACK

DISASSEMBLY AND ASSEMBLY TRANSMISSION 4. End plate 1) Install tools B3 and B5, then tighten tool B4 to push in end plate (72). 2) Assemble ring (73) and remove tool B3. Ъ Check that the disc rotates smoothly by hand. 5. Thrust washer Assemble thrust washer (55). 6. 2nd gear Assemble 2nd gear (54), then assemble needle bearing (53). Ъ If the gear spline does not match, turn lightly when assembling. Never use force to push it in. 7. Idler gear Assemble thrust washer (35), then assemble idler gear (50). Ъ Check that the end face of the thrust washer is below the surface of the stepped portion of the shaft. 8.

Bearing After assembling the idler gear, install snap ring (50-1), and press fit bearing (51). Ъ Fit the snap ring securely in the groove. Ъ After press fitting the bearing, check that clearance "e" between the thrust washer and idler gear is within the specified range. e = 0.04 - 1.16 mm 30-82 WA250-3L