Komatsu — INSTALLATION

DISASSEMBLY AND ASSEMBLY TRANSMISSION CONTROL VALVE INSTALLATION ! Carry but installation in the reverse order of removal. Ъ Connect the wiring connector securely. Mouthpiece nut: 196.1 ± 2:49.0 Nm (20.0 ± 5.0 kgm) (Width across flats: 41 mm) Mouthpiece nut: 176.5 ± 29.4 Nm (18.0 ± 3.0 kgm) (Width across flats: 36 mm) WARNING! The working space is confined, so be extremely careful. Ъ When installing the transmission valve, replace the gasket with a new part. Ъ When installing the transmission valve, use guide bolts to prevent it from falling. Ъ Secure with upper and lower valve set bolts (13) and (14). Ъ Remove all oil and grease from the valve mounting bolts and mounting bolt holes.

Mounting bolt:: Thread tightener (LT-2) Mounting bolt:: 34.3 ± 4.9 Nm (3.5 ± 0.5 kgm) Ъ To prevent distortion of the valve, tighten the transmission valve mounting bolts in the order shown in the diagram. Mounting bolt length ( R ): R = 100 mm (1, 6, 8, 12) R = 120 mm (4, 7, 1 0, 11) R = 130 mm (2, 9) R = 135 mm (3, 5) Refilling with oil ! Tighten drain plug and add transmission oil through oil filler to the specified level. ! Transmission oil: 35 R 30-91 WA250-3L