Komatsu — INSTALLATION

DISASSEMBLY AND ASSEMBLY FRONT AXLE INSTALLATION ! Carry out installation in the reverse order of removal. Ъ Raise the front frame slightly with the bucket, and remove block в . Ъ Raise tire and wheel (1) and set to the mounting position, then tighten mounting bolts. Mounting bolt: 926.7 ± 103.0 Nm (94.5 ± 10.5 kgm) (Width across flats: 36 mm) Ъ Connect front drive shaft (2). Drive shaft: 66.2 ± 7.4 Nm (6.75 ± 0.75 kgm) Ъ Be careful not to tighten the tube nut too far. Tube nut: 11.8 ± 2.9 Nm (1.2 ± 0.3 kgm) Ъ Use the bolts as a guide and align the mounting position. Mounting bolt: 676.7 ± 68.6 Nm (69.0 ± 7.0 kgm) (Width across flats: 36 mm) Ъ Use a hoist and jack for the operation. !

Bleeding air from brake system Ъ Bleed the air from the brake system. For details, see TESTING AND ADJUSTING, Bleeding air from brake system. 30-105 WA250-3L