DISASSEMBLY AND ASSEMBLY REAR AXLE INSTALLATION ! Carry out installation in the reverse order of removal. Mounting bolt: 926.7 ± 103.0 Nm (94.5 ± 10.5 kgm) (Width across flats: 36 mm) Ъ Align the pilot portion securely and take care to assemble with the yoke facing in the correct direction. Mounting bolt: 66.2 ± 7.4 Nm (6.75 ± 0.75 kgm) Ъ Be careful not to tighten the brake hoses too far. Mounting hose: 11.3 ± 3.4 Nm (1.15 ± 0.35 kgm Ъ Use the bolt as a guide and set to the mounting position. Ъ When tightening the mounting bolts, do not tighten in one step. Divide the torque and tighten in three steps. Ъ After installing the axle assembly, remove the wire. Mounting bolt:
676.7 ± 68.6 Nm (69.0 ± 7.0 kgm) (Width across flats: 36 mm) Adjusting rear pivot shim 1) Measure dimension a of trunnion cap (7) at 4 places on diagonally opposite sides with depth micrometer в and take the average. Ъ Wipe the measurement surface clean before measuring. ! Standard value a: 19.85 - 20.0 mm 30-110 WA250-3L