DISASSEMBLY AND ASSEMBLY REAR AXLE 2) Assemble thrust washer (8) to rear pivot, then measure dimension b at 4 places on diagonally opposite sides with depth micrometer в and take the average. Ъ Wipe the mating surface of the thrust washer and thrust plate clean before measuring. Ъ Wipe the contact surface of the probe clean before measuring. ! Reference value for b: 19.65 - 20.0 mm Ъ Insert a feeler gauge between circumference c and the joint of the thrust washer and the thrust plate, and check that there is no clearance. Ъ Measure a - b = t at the joint of the rear pivot and trunnion cap, and determine the number and thickness of the shim.
Ъ Select the number and thickness of shims within the range below. Ъ Thickness of 1 shim = 0.2 mm Ъ t mm (shim thickness) Number of shims 0 - 0.07 1 0.08 - 0.27 2 0.28 - 0.47 3 3) Assemble selected shim between rear pivot (11) and trunnion cap (7), and install mounting bolts. Ъ Fill the trunnion cap with grease, then install. Trunnion cap: Grease (G2-L1) Mounting bolt: 12.8 ± 9.8 Nm (11.5 ± 1.0 kgm) Ъ Assemble so that the chamfered portion d of thrust washers (8) and (10) is on thrust cap (7) side. Ъ Clean the mating surface of the thrust washer and thrust plate. Ъ Assemble so that the chamfered portion of the thrust washer is on the thrust plate side. Outside circumference of pivot mount:
Grease (G2-L1) Mounting bolt: Thread tightener (LT-2) Mounting bolt: 112.8 ± 9.8 Nm (11.5 ± 1.0 kgm) 30-111 WA250-3L