Komatsu — INSTALLATION

DISASSEMBLY AND ASSEMBLY REAR AXLE 1) Be careful not to get the packing caught. 2) To make the axle and support parallel, turn the trunnion cap over and tighten uniformly with the 8 bolts. Mounting bolt: 68.6 ± 9.8 Nm (7.0 ± 1.0 kgm) Ъ Remove the grease tube elbow first. Ъ Check that the clearance between the pivot and trunnion cap is uniform. Ъ Set on the chassis mount with the cap still reversed. Ъ Assemble so that the chamfered side of the packing is on the axle housing side. Ъ Set the packing with the join at the side. Packing: Grease (G2-L1) Ъ Assemble with the lip of the packing facing the outside. ! Bleeding air from brake system Ъ Bleed the air from the brake system.

For details, see TESTING AND ADJUSTING, Bleeding air from brake 30-112 WA250-3L