Komatsu — ASSEMBLY

DISASSEMBLY AND ASSEMBLY DIFFERENTIAL ASSEMBLY 1. Pinion gear 1) Press fit bearing cone (28) in pinion gear (25), then assemble spacer (27). Ъ There must be no clearance at the contact surface of any parts. 2) Press fit bearing cups (29) and (30) in cage (5). 3) Assemble pinion gear (25) in cage (5), then press fit bearing cone (26). Ъ The front pinion gear and rear pinion gear are different, so be careful not to mistake them when installing. Ъ Apply pressure to the bearing at the specified load, and rotate the cage to settle the Press load: 5 ton Bearing: Oil (axle oil) Ъ When rotating the cage at the specified Load, rotate lightly by hand.

If the rotation is not smooth, replace the bearing and spacer, and check that rotate lightly by hand again. 4) Press fit oil seal (24) to cage (5). Ъ Press fit oil seal (24) until it is level with the surface. Lip of oil seal: Grease (G2-L1) Pinion gear shaft: Grease (G2-L1) 30-117 WA250-3L