DISASSEMBLY AND ASSEMBLY DIFFERENTIAL 10. Bearing carrier Remove bearing carrier (7), assemble Square-ring (36), then install together with adjusted shims (36). Ъ Coat the Square-ring with grease, and be careful not to let it fall when assembling. Ъ When installing bearing carrier (7), the Square-ring may fall out, so do not use a hammer to install. Square-ring: Grease (G2-L1) Mounting bolt: 112.8 ± 9.8 Nm (11.5 ± 1.0 kgm) 11. Brake piston 1) Fit O-ring (37) and (38) securely in grooves of brake piston (6) and bearing carrier (7) Ъ Coat the brake piston and piston mount lightly with grease to prevent the O-ring from twisting or breaking. Piston and piston mount surface:
Oil (axle oil) 2) Install piston press-fitting tool D2 to differential housing , then tighten screws (39) uniformly to press fit. Ъ Press fit the piston until it contacts the housing. Ъ If using a plastic hammer to tap in, be careful not to damage the O-ring and piston. 12. Checking for leakage of break oil 1) Install bleeder screw. 2) Tighten all screws (39) of piston press-fitting tool D2 completely, then turn back one turn. 3) Install tool D3 to brake tube mount (44), then bleed air from inside cylinder.
4) Operate pump and raise pressure to 1.4 MPa (14 kg/c M ) 2 Ъ After raising the pressure to 1.4 MPa (14 kg/cm ) leave 2 for 5 minutes and check that the drop in pressure is less than 0.33 MPa (3.5 kg/cm ) 2 30-124 WA250-3L