DISASSEMBLY AND ASSEMBLY DIFFERENTIAL 5) If the test shows that there is no leakage of oil, raise pressure to 1.4 MPa (42 kg/cm ) 2 Ъ After raising the pressure to 1.4 MPa (42 kg/cm ) , leave 2 for 5 minutes and check that the drop in pressure is less than 0.33 MPa (3.5 kg/cm ) . 2 Ъ If there is any leakage of oil, remove the brake piston and check the O-ring for damage, then reassemble. Ъ After checking for leakage of break oil, insert piston fully. 13. Coupling Tighten mounting bolts of coupling (22). Mounting bolt: Adhesive (LT-2) Mounting bolt: 279.5 ± 29.4 Nm (28.5 ± 3.0 kgm) 14. Differential cover 1) Install differential cover (3) on differential, housing.
Ъ Install a guide bolt in the mount hole of the bleeder screw to prevent gasket sealant from entering the hole. Cover contact surface: Gasket sealant (Loctite 515) Mounting bolt: 112.8 ± 9.8 Nm (11.5 ± 1.0 kgm) 2) Remove guide bolt and install bleeder screw (2). Ъ Check that there is no gasket sealant in the screw hole when installing. Ъ The front and rear axle housings are different, so be careful not to mistake them when installing the housing assemblies. 30-125 WA250-3L