Komatsu — DISASSEMBLY

DISASSEMBLY AND ASSEMBLY AXLE HOUSING 2) Put a copper hammer in contact with end face of axle shaft (9), knock in shaft and remove it, then remove bearing. Ъ Push out the axle shaft a short distance and use a screw driver to remove portion a of oil seal (15) to prevent bearing (16) from damaging the oil seal. 3) Remove bearing (16) and seal (15) from axle shaft (9). Ъ Remove the bearing as follows. 4) When removing bearing (16) of shaft (9), use a screw driver to push in circumference of portion a of oil seal and sleeve (15) uniformly towards flange. 5) Make clearance c to allow claws of puller to be fitted to contact portion of sleeve (15-1) and bearing (16).

6) Install bolt (30)(5/8-18UNF R = Approx. 60 mm) to portion b of bearing puller E1 Ъ Screw the bolt fully into the thread. 7) Set bearing puller E1 to clearance portion c of sleeve (15-1) and bearing (16), then assemble bolts E2 and nuts E3. Ъ When doing this, fix securely to prevent any play in the bearing. 30-128 WA250-3L