DISASSEMBLY AND ASSEMBLY AXLE HOUSING 8) Insert washer between bolt (30) and flange surface, turn bolt (30) to loosen it, and remove bearing (16). Ъ The puller has little grip on the bearing, so be extremely careful that the puller does not come off from the bearing. Ъ If the thread of bolt (30) is too short, add a washer to the flange surface to adjust the height of bolt (30) when removing bearing (16). Ъ Replace the oil seal and sleeve assembly with a new part. 7. Ring gear Using puller, raise horizontally and remove ring gear (17). 8. Axle housing Remove bearing cups (18) and (19) from axle housing (4). 30-129 WA250-3L