Komatsu — ASSEMBLY

DISASSEMBLY AND ASSEMBLY AXLE HOUSING ASSEMBLY Ъ When assembling the final drive of the front axle and rear axle, check the marks made when disassembling. 1. Axle housing Press fit bearing cups (18) and (19) to axle housing (4). Ъ After press fitting the cups, check that there is no clearance at portion a. Cup press-fitting portion, rolling surface : Axle oil 2. Ring gear Press fit ring gear (17) to axle housing (4), and insert pin (26). Ъ Align the pin hole of the ring gear and the housing, then assemble the ring gear. Ъ Cool ring gear (17) with dry ice at approx.-30 E C before press fitting. 3. Axle shaft 1) Assemble outer oil seal (28) to inner oil seal (27).

Ъ Check that the lip of the oil seal is coated with grease. Grease (G2-L1) 2) Using press, press fit oil seal to axle shaft (9). Ъ In order not to deform the oil seal, do not tap with a hammer. Ъ Sleeve press-fitting surface b of oil seal: Axle oil Contact surface b of sleeve: Axle oil 3) Set bearing (16) on press stand, then press fit axle shaft (9). Ъ Be careful not to install the bearing at an angle. Bearing press-fitting portion: Axle oil 30-131 WA250-3L