DISASSEMBLY AND ASSEMBLY AXLE HOUSING 4. Housing, shaft 1) Stand shaft (9) vertically and install tool E4. Ъ Adjust the height of the seal support with the adjustment bolts, put the top surface of tool E4 in light contact with seal (15), then set so that the clearance is uniform. Ъ Set tool E4 securely so that it does not come off. 2) Raise housing (4) horizontally and insert to shaft slowly. Ъ Stop housing (4) at a point before the oil seal is press fitted. Oil seal press-fitting portion: Axle oil 3) Align housing (4) with oil seal press-fitting portion, then lower housing slowly. Ъ Use the weight of the axle housing to insert it.
Ъ After assembling the housing, check that seal surface a and jig surface b are level with the surface. If there is a clearance at portion a, check that the clearance is uniform. 4) Remove tool E4. 5) Use a press to press fit bearing (29) to shaft (9), then rotate housing by hand to settle bearing. Ъ Press-fitting force: Approx. 19.6 KN (2 ton) Bearing cone press-fitting portion: Axle oil 30-132 WA250-3L