Komatsu — ASSEMBLY

DISASSEMBLY AND ASSEMBLY AXLE HOUSING 5. Adjusting end play 1) Stand axle shaft and housing assembly (4) upright, and secure flange portion a. 2) Install planetary carrier (11) to spline of axle shaft (9), then assemble shim adjustment tool в to portion c of planetary carrier, and install mounting bolts. Ъ Install planetary carrier (11) without the gears. Ъ Remove all adhesive from the mounting bolts and mounting bolt holes of the axle shaft before using. 3) Rotate axle housing (4) and tighten retainer mounting bolts (26). Bolt: 44.1 Nm (4.5 kgm) 4) Make sure that bearing (29) is fully settled, then measure starting torque "X" at drill hole b of axle housing (4). Ъ Starting torque "X":

18.6 - 60.8 N (1.9 - 6.2 kg) ! If starting turning force is not within the standard value, adjust again as follows. Ъ If starting turning force is less than 18.6 N (1.9 kg) Press fit bearing (29) again and repeat the operation from Step 3). Ъ If starting turning force is more than 60.8 N (6.2 kg) i) Use method in Step 5) to measure dimension H and dimension t. ii) Remove mounting bolt (26) and tool (1), and insert shim. Ъ Shim thickness: (H - t) + 0.1 mm iii) Tighten tool в again with mounting bolt (26). Ъ Tightening torque:

44.1 Nm (4.5 kgm) iv) Secure axle housing (4) in position shown in diagram on right, then tap flange of axle shaft (9) with a copper hammer several times in a downward direction to remove axle shaft. 30-133 WA250-3L