DISASSEMBLY AND ASSEMBLY AXLE HOUSING v) Rotate axle housing again to settle bearing, then measure starting turning force at drill hole b again. ! Repeat this operation until the starting turning force is 18.6 - 60.8 N (1.9 - 6.2 kg). vi) Remove bolt (26) and tool в remove shim, then assemble tool в again and tighten bolt. ! Tightening torque: 44.1 Nm (4.5 kgm) 5) Using depth micrometer, measure distance H from shim adjustment tool в to end face of axle shaft. Subtract thickness t of the jig from H to give the value (H - t). Ъ Shim thickness X = (H - t) +0.10 -0 Ъ Select a shim to give the value closest to (H - t) + 0.05 mm .
6) After deciding shim, loosen bolt and remove planetary carrier (11). 6. Planetary carrier 1) Assemble bearing cone (23) to gear (22), and set in carrier (11). Ъ Insert spacer (25) inside the planetary carrier before starting. 2) Press fit shaft (21). Ъ Align the holes of shaft (21) and spring pin (20), and knock in the spring pin so that it is level with the surface of the carrier. Ъ Pressing force : 49.0 KN (5 ton) Shaft: Oil (axle oil) 3) Tap differential end of gear (28) and end face of shaft (27), and push back bearing (29) so that the gear can rotate smoothly. Ъ Check that the gear rotates smoothly. 30-134 WA250-3L