Komatsu — ASSEMBLY

DISASSEMBLY AND ASSEMBLY AXLE HOUSING 7. Planetary carrier 1) Assemble shim (24) selected in Step 5) to end face of axle shaft, then install planetary carrier assembly (11) and install mounting bolts. Ъ Wash and remove all oil and grease from mounting bolts and mounting bolt holes of axle shaft. Mounting bolt: Thread tightener (LT-2) Mounting bolt: 549.2 ± 58.8 Nm (56.0 ± 6.0 kgm) Ъ Clean the end face of the shaft and the planetary carrier spline before assembling. WARNING! When assembling the planetary carrier, be extremely careful not to get your fingers caught in the gear.

2) Make sure that bearing (29) is fully settled, then check starting turning force "X" at drill hole b of axle housing assembly (4).Starting turning force X: 18 .6 - 70.6 N (1.9 - 7.2 kg) 3) Install stand of dial gauge to axle housing (4), then measure end play of planetary carrier at end face of planetary carrier. Ъ End play of planetary carrier: 0 - 0.1 mm Ъ If the starting turning torque and end play are not within the standard range, carry out the adjustment in Step 5 again. 8. Brake outer ring 1) Assemble brake outer ring (8) to axle housing. Ъ Align outer ring pin hole and pin, then assemble. Ъ Be careful not to damage the surface of the brake outer ring. 30-135 WA250-3L