DISASSEMBLY AND ASSEMBLY AXLE HOUSING 2) Assemble brake disc (6) and sun gear shaft (5) inside axle housing. 9. Axle housing 1) Assemble brake ring (7) to differential housing. Ъ Check that there is no damage to the surface of the brake ring when assembling. 2) Raise axle housing (4) horizontally, then align spline groove and pin hole, and assemble slowly. Ъ When assembling, be careful not to let the brake ring and disk come out of place. Ъ Wash and remove all oil and grease from the axle housing and differential housing mounting surface, then coat with a continuous line of gasket sealant so that there is no break. Mating surface of housing:
Gasket sealant (Loctite 515) Housing mounting bolt: 279.5 ± 29.4 Nm (28.5 ± 3.0 kgm) 10 . Differential cover 1) Knock pin in differential housing and install differential cover (3). Ъ Coat with a continuous line of Loctite so that there is no break. Ъ Be careful not to get any gasket sealant in the bleeder screw mounting hole when assembling. Cover mating surface: Gasket sealant (Loctite 515) Cover mating surface: 112.8 ± 9.8 Nm (11.5 ± 1.0 kgm) 2) Install bleeder screw (2). 11. Refilling with oil Tighten drain plug and add axle oil through oil filler (31) to the specified level. Axle oil: 17.5 R 30-136 WA250-3L