Komatsu — REMOVAL

DISASSEMBLY AND ASSEMBLY CENTER HINGE PIN CENTER HINGE PIN REMOVAL WARNING! Stop the machine on level ground and install the safety bar on the frame. Lower the bucket to the ground and stop the engine. Then apply the parking brake and put blocks under the wheels to prevent the machine from moving. WARNING! Remove the cover at the top of the hydraulic tank, and loosen the oil filler cap slowly to release the pressure inside the hydraulic tank. Then operate the steering wheel and control levers several times to release the remaining pressure in the hydraulic piping. ! Loosen the plug at the top of the hydraulic tank filter to prevent the oil inside the hydraulic tank from flowing out.

For details, see REMOVAL OF TRANSMISSION, TORQUE CONVERTER ASSEMBLY. WARNING! Disconnect the cable from the negative (-) terminal of the battery. Ъ Set a pallet under the bucket. 1. Bodywork 1) Remove cover (2) under cab. Ъ Remove the cover at the front on the opposite side also. 2) Remove ladder assembly (3). Ъ Remove the ladder on the opposite side also. 2. Drive shaft Disconnect center drive shaft (4). Ъ Set a block under the drive shaft and disconnect. Center drive shaft: 20 kg 3. Disconnect parking cable (5) from transmission. 4. Air conditioner, heater hoses 1) Disconnect air conditioner hoses (6) and (7). 2) Loosen clamps of heater hoses (8) and (9) and disconnect from hose.

Ъ After disconnecting the hoses, fit covers to prevent dirt, dust, or water from entering the mouthpiece. Ъ Carry out the air return operation for the compressor, then use a gauge manifold band release the refrigerant slowly from the high-pressure valve. 30-137 WA250-3L