DISASSEMBLY AND ASSEMBLY STEERING VALVE 18. Turn spool and sleeve assembly to make pin (18) and port surface of housing parallel, then mesh pin and yoke of drive shaft (7). Ъ To position accurately, draw a line on the end face of the drive shaft spline. 19. Insert O-ring (5) in rotor set (4). 20. Make O-ring (5) end of rotor set to spacer plate end, then align insert portion of star of rotor (4) with drive. 1) Check that lines A,B,C, and D are all parallel. 2) Without removing joint of drive (7), position bolt holes of rotor set. Ъ This procedure is very important for determining the valve timing of unit. 21. Insert spacer (6) inside rotor set. 22.
Set end cap (2) on rotor set, and align bolt hole. 30-157 WA250-3L