Komatsu — ASSEMBLY

DISASSEMBLY AND ASSEMBLY STEERING VALVE 11. Insert dust seal (14) in bushing (12). 12. Insert X-ring seal (13) in bushing (12). 13. Insert bushing (12) in spool, and rotate to install. ! Tap with a plastic hammer to assemble to the specified position. ! It must be in contact horizontally with the bearing race. 14. Fit snap ring (11) in housing. ASSEMBLY OF ROTOR 15. Hold flange of housing lightly in vice. Ъ Be careful not to tighten the vice too hard. Ъ Check that the spool and sleeve are set in slightly from the housing surface with fourteen holes. 16. Insert O-ring (9) in housing. 17. Put on spacer plate (8), and align positions of bolt hole and tap hole of housing. 30-156 WA250-3L