Komatsu — ASSEMBLY

DISASSEMBLY AND ASSEMBLY STEERING VALVE 6. Align spring groove positions of spool (20) and sleeve (19), and set on flat plate, then insert spring (21) in spring groove. Ъ Set so that the notches at both ends are at the bottom. 7. Insert pin (18) in spool and sleeve assembly (17). 8. Insert spool and sleeve assembly (17) in housing (10) in the direction of the arrow. 1) Keep pin horizontal and rotate to left and right a little at a time to insert. Ъ Be extremely careful not to get it caught. 2) Make the spool and sleeve assembly flush with the rear end face of the housing. Ъ If it is inserted beyond the end face, the pin will fall out.

3) Check that spool and sleeve rotate smoothly inside housing. 9. Install O-ring (22) to housing (10). 10. Fit 2 bearing races (15) and thrust needle (16) in case (10). 30-155 WA250-3L