DISASSEMBLY AND ASSEMBLY STEERING VALVE STEERING VALVE ASSEMBLY Ъ Check all parts for damage or burrs. Ъ Wash all metal parts in clean solvent and blow dry with air. Ъ Do not use a file or polish any part with rough sandpaper. Ъ Coat the O-rings with clean grease. (No need to put grease on new X-ring seals) Ъ Coat the O-ring for the rotor set with a small amount of grease. ASSEMBLY OF CONTROL SIDE 1. Insert retainer (28) in housing with tweezers. Ъ Check that the retainer is not inserted at an angle. 2. Insert ball (27). 3. Fit O-rings (26) and (25) in check sheet (24), and push check sheet (24) into housing.
Ъ Be careful to set the top and bottom of the check sheet facing in the correct direction. 4. Install set screw (23). Ъ Check that the set screw is set in slightly from the end face of the housing. Set screw: 11.8 Nm (1.2 kgm) Set screw : Adhesive (LT-2) 5. Assemble spool (20) and sleeve (19) so that spring groove is on same side. Ъ Rotate the spool and slide it in. Ъ Grip the splined portion of the spool lightly and check that the spool rotates smoothly inside the sleeve. Ъ If there are match marks, check that the match marks are aligned. 30-154 WA250-3L