DISASSEMBLY AND ASSEMBLY STEERING VALVE 14. Remove 2 bearing races (15) and thrust needle (16) from spool and sleeve. 15. Pull out spool and sleeve assembly (17) from housing (10) in the direction of the arrow. Ъ To prevent the spool and sleeve assembly from catching in the housing, rotate the spool and sleeve assembly slowly to the left and right when pulling out from the housing. 16. Pull out pin (18) from spool and sleeve assembly (17) 17. Push spool (20) inside sleeve (19) slightly to front, and remove 6 centering springs (21) from spool (20) carefully by hand. 18. Turn spool (20) slowly and pull out from rear of sleeve (19) (in the direction of the arrow). 19.
Remove O-ring (22) from housing. 20. Remove set screw (23) from housing. 21. Screw a threaded bar into check sheet (24), and pull out check sheet (24). 22. Remove O-rings (25) and (26) from check sheet 24. 23. Tap housing, and remove ball (27) and retainer (28). 30-153 WA250-3L