DISASSEMBLY AND ASSEMBLY MAIN CONTROL VALVE DISASSEMBLY ASSEMBLY 1. Spool assembly 1 . Assemble valve (28) and spring (27) in body (29), and 1) Remove mounting bolt (2) and plug (3) of detent fit O-ring and tighten plug (26). assembly (1). 2) Holding spool (4) from moving, loosen bolt (5) Plug: 107.8 ± 14.7 Nm (11 ± 1.5 kgm) inside detent assembly (1), then remove detent assembly (1). 2. Fit O-rings and install suction valve assembly (24) Ъ Remove joint (6) from spool (4). and safety valve assembly (25) with suction valve. 3) Remove retainer (7), spring (8), retainer (9), oil seal (10) and plate (11). Safety valve (with suction):
4) Remove plate (12), then remove oil seal (10) and 142.2 ± 19.6 Nm (14.5 ± 2 kgm) spool (4). 2. Main relief valve assembly (14.5 ± 2 kgm) 1) Remove main relief valve assembly (13). 2) Loosen nut (14), and screw out holder (15), then 3. Main relief valve assembly remove retainer (16), spring (17), poppet (18), 1) Assemble valve (22) in sleeve (23), then tighten seat (19) and spring (20). plug (21). 3) Remove plug (21), then remove valve (22) from 2) Assemble spring (20), seat (19), poppet (18), sleeve (23). spring (17) and retainer (16) in sleeve. Ъ Valve (22) and sleeve (23) are not available as 3) Screw nut (14) into holder (15), fit O-ring on individual parts, so replace them as a set.
holder, then install the holder into sleeve (23) Suction valve: 142.2 ± 19.6 Nm 3. Remove safety valve assembly (25) with suction valve 4) Fit O-ring and backup ring and install main relief and suction valve assembly (24). valve assembly (13). and tighten nut (14). 4. Remove plug (26), then remove spring (27) and valve Main relief valve: 83.4 ± 14.7 Nm (28). (8.5 ± 1.5 kgm) 4. Spool assembly 1) Assemble spool (4) in body, then install oil seal (10) and plate (12). 2) Pull out spool slightly, then assemble retainer (11), oil seal (10), retainer (9), spring (8), and retainer (7). 3) Hold spool from moving, turn bolt inside detent assembly (1), and install joint (6) to spool (4). Joint:
14.7 ± 4.9 Nm (1.5 ± 0.5 kgm) 4) Tighten bolt (5), then install detent assembly (1). 5) Tighten plug (3). Plug: 13.7 ± 3.9 Nm (1.4 ± 0.4 kgm) 30-164 WA250-3L