DISASSEMBLY AND ASSEMBLY STEERING CYLINDER STEERING CYLINDER REMOVAL WARNING! , Stop the machine on level ground and install the safety bar on the frame. Lower the bucket to the ground and stop the engine. Then apply the parking brake and put blocks under the wheels to prevent the machine from moving WARNING! . Loosen the oil filler cap slowly to release the pressure inside the hydraulic tank. Then operate the steering wheel several times to the left and right to release the remaining pressure in the 1. Hydraulic piping Disconnect hoses (1) and (2) from cylinder. 2. Steering Cylinder 1) Remove rod bolt, and pull out pin (3).
Ъ Check the number and thickness of the shims and use for reference when assembling. 2) Remove bottom bolt, and pull out pin (4). 3) Remove steering cylinder (5) Ъ When removing the cylinder, carry out the operation with two workers. Be careful not to damage the cylinder rod. Steering cylinder: 20 kg INSTALLATION ! Carry out installation in the reverse order of removal. WARNING! When aligning the position of the pin hole, use a bar. Never insert your fingers in the pin hole. 1. Adjust the shim so that the total of clearance a is the specified value. Ъ Clearance a: 0 - 0.5 mm 2. Grease the cylinder pin thoroughly. Ъ Wipe off any grease that is squeezed out. 30-165 WA250-3L