DISASSEMBLY AND ASSEMBLY POWER MASTER CYLINDER POWER MASTER CYLINDER REMOVAL WARNING! Stop the machine on level ground and install the safety bar on the frame. Lower the bucket to the ground and stop the engine. Then apply the parking brake and put blocks under the wheels to prevent the machine from moving. 1. Cover Remove side covers (1) and (2). 2. Brake piping 1) Disconnect hose (3) between power master cylinder and transmission from power master cylinder. 2) Disconnect hose (4) between power master cylinder and torque converter charging pump from power master cylinder. 3) Disconnect hoses (5) and (6) between brake oil tank and power master cylinder from power master cylinder.
4) Disconnect tubes (7) and (8) between power master cylinder and front and rear brakes from power master cylinder. 5) Disconnect hose (9) between power master cylinder and transmission from power master cylinder. 3. Power master cylinder 1) Remove brake lever connecting nut of brake rod assembly (10). 2) Remove 4 mounting bolts (11), then remove power master cylinder (12). 30-166 WA250-3L