Komatsu — DISASSEMBLY

DISASSEMBLY AND ASSEMBLY POWER MASTER CYLINDER 3) Remove spring (12) from inside body (4). Ъ When removing the piston, be careful not to damage the inside of the body or the sliding surface of the piston. Ъ If there is any problem with the primary or secondary pistons, replace the master cylinder assembly. 3. Disassembly of power cylinder 1) Remove dust cover (13). Ъ Remove the elbow first. 2) Push in cylinder cover (14), remove snap ring (15), then remove power piston (16), connector assembly (17), spring seat (18), and springs (19) and (20). WARNING! When removing the snap ring, the cylinder cover is pushed out by the spring, 17 so remove carefully.

3) Remove power piston (16) from connector assembly (17). 4) Remove snap ring (21), disconnect spool (22 and connector, then remove thrust washer (23) and spring (24). 30-169 WA250-3L