Komatsu — REMOVAL

DISASSEMBLY AND ASSEMBLY PARKING BRAKE DISC PARKING BRAKE DISC REMOVAL WARNING! , Stop the machine on level ground and install the safety bar on the frame. Lower the bucket to the ground and stop the engine. Then apply the parking brake and put blocks under the wheels to prevent the machine from moving. 1. Draining oil Loosen drain plug (2) and drain transmission oil. Transmission oil: 35 R Ъ After loosening the drain plug, pull it out gradually and drain the oil. 2. Center drive shaft Disconnect center drive shaft (2) from transmission. 3. Linkage Remove lever pin (3). Ъ Check that the parking brake is released. 4. Yoke Remove yoke (4). 5.

Cover Remove plug (5), install temporary stopper bolts M8x35 (6), then remove cover (7) and piston (8) as assembly. Ъ Be careful not to damage the oil seal. Ъ Install forcing screws and guide bolts. Cover assembly: 15.5 kg 30-176 WA250-3L