Komatsu — INSTALLATION

DISASSEMBLY AND ASSEMBLY PARKING BRAKE DISC 6. Disc Install tool F , tighten with yoke mounting bolt (9) so that tool F pushes in plate, then remove snap ring (10) and remove separator plate (11), wave spring (12), and disc (13). Ъ Before installing the tool, install M10 bolts-to the jig. INSTALLATION ! Carry out installation in the reverse order of removal. Mounting bolt: 274.6 ± 29.4 Nm (28.0 ± 3.0 kgm) ! Adjusting linkage For details, see TESTING AND ADJUSTING. ! Refilling with oil Tighten drain plug and add transmission oil through oil filler to the specified level. Ъ Run the engine to circulate the oil through the system. Then check the oil level again. Transmission oil:

35 R 30-177 WA250-3L