Komatsu — REMOVAL

DISASSEMBLY AND ASSEMBLY BUCKET CYLINDER BUCKET CYLINDER REMOVAL WARNING! Stop the machine on level ground and install the safety bar on the frame. Lower the bucket to the ground and stop the engine. Then apply the parking brake and put blocks under the wheels to prevent the machine from moving. WARNING! ! Remove the cover at the top of the hydraulic tank, and loosen the oil filler cap slowly to release the pressure inside the hydraulic tank. Then operate the steering wheel and control levers several times to release the remaining pressure in the hydraulic piping. 1. Bucket positioner Disconnect connector (1). Ъ Remove the wiring clamp and bracket. 2.

Rod pin Sling cylinder, remove lock bolt, then remove pin (2). Ъ Be careful of the center of gravity when slinging, and lift at two places. 3. Hydraulic piping 1) Disconnect rod hose (3) from cylinder. 2) Disconnect tube (4) and hose (5) at bottom end from connecting portion. 4. Bucket cylinder 1) Remove lock bolt, then remove bottom pin (6). Ъ If there are shims, check the number and thickness of the shims, and keep in a safe place. 2) Lift off bucket cylinder (7). Ъ Be careful not to damage the cylinder rod. Bucket cylinder: 80 kg 30-182 WA250-3L