Komatsu — INSTALLATION

DISASSEMBLY AND ASSEMBLY WORK EQUIPMENT STEERING PUMP WORK EQUIPMENT, STEERING PUMP REMOVAL WARNING! Stop the machine on level ground and install the safety bar on the frame. Lower the bucket to the ground and stop the engine. Then apply the parking brake and put blocks under the wheels to prevent the machine from moving. WARNING! ! Remove the cover at the top of the hydraulic tank, and loosen the oil filler cap slowly to release the pressure inside the hydraulic tank. Then operate the steering wheel and control levers several times to release the remaining pressure in the hydraulic piping. !

Loosen the plug at the top of the hydraulic tank filter to prevent the oil inside the hydraulic tank from flowing out. For details, see REMOVAL OF TRANSMISSION, TORQUE CONVERTER. 1. Covers Remove transmission side cover (2), hood front cover (3), and hood side cover (4). 2. Hydraulic piping 1) Disconnect tube (5) between hydraulic tank and hydraulic, steering pump from pump. 2) Disconnect hoses (6) and (7) between hydraulic, steering pump and priority valve from pump. 3. Hydraulic, steering pump.

Sling hydraulic and steering pump (8), and remove mounting bolts (9), then remove pump (8) Ъ When removing the pump, carry out the operation with two workers, and remove from the bottom inspection port. Ъ The working space is confined, so be extremely careful. Hydraulic, steering pump: 13 kg INSTALLATION ! Carry out installation in the reverse order of removal. Ъ Add hydraulic oil to the specified level. Ъ Run the engine to circulate the hydraulic oil through the system. Then check the oil level again. Ъ Check that there is an O-ring between the pump and housing. 30-181 WA250-3L