Komatsu — ASSEMBLY

DISASSEMBLY AND ASSEMBLY HYDRAULIC CYLINDER ASSEMBLY Ъ Clean all parts, and check for dirt or damage. Coat the sliding surfaces of all parts with engine oil before installing, and be careful not to damage the rod packings, dust seals, or O-rings when assembling. 1. Assembly of cylinder head assembly 1) Using tool K , press fit bushing (14) to cylinder head (16). Ъ Be careful not to deform the bushing when press fitting. 2) Assemble rod packing (15). Ъ Be careful to assemble the rod packing facing in the correct direction. 3) Using tool L, install dust seal (13) to head (16). 4) Install snap ring (12). 5) Install backup ring (18) and O-ring (17).

Ъ Do not try to force the backup ring into position. Warm it in warm water (50 - 60'C) before fitting it. 2. Assembly of piston assembly 1) Using tool M1, expand piston ring (10). Ъ Set the piston ring on the tool and turn the handle 8 - 10 times to expand the ring. 2) Remove piston ring (10) from tool M1, then assemble to piston (11). 3) Fit piston ring, then using tool M2, compress piston ring. 4) Assemble wear ring (9). 30-188 WA250-3L